Excavator training course +27731582436
its good machine mainly used in trenching, digging for excavator licence holder
The basic components that make up the backhoe include
first and foremost its recommendable to always check your operator manual for whatever piece of heavy equipment you need to operate, excavator certificate, since you going to have individual checklist for your equipment.
Pre operation inspection is the most piece of work of your day you need to daily before you start the operation of the excavator. So you don’t need to overlook the walk around of the machine.
The main aim of a pre-op inspection to look for damage, leaks..
You start from the driver cabin looking for obvious broken glasses, mirror etc.
Most important you look for leaks at the undercarriage so you look at the idlers in front, the final drive in the front, underneath the excavator, hydraulic lines & cylinders and make sure all compartments are sealed.
You have to look at the roller, trackpads/shoe(bend/broken), sprocket, swing or table for wear and damage
you need check loose or missing bolts and trackpad undercarriage and you should take note of the track sag whether its tight or loose.
Excavator training Centre ( 0731582436)
Excavator training price: R5,000
Excavator course Duration: 1 week.
Excavator operator training Award: excavator certificate & excavator license
Expiry: after 2 years of issue
Excavator Salary Expectation: R8000-R25000
Unit standard: 252744
Level: nqf level 2
Credits: 15
------------------
Call us / Whatsapp; +27731582436
Email us : mulanioperators@yahoo.cm
Tel: 0118241189 / 0604291718 / 0731582436
---------------------------------------------------
The cutting teeth, weld plates on bucket for wear and damage and all pins and bolts are in place.
You have to check the compartments for leaks or damage and clean(free of debris) these include the air filter or cooling compartment, hydraulic oil levels, diesel exhaust fluid, deep stick for swing oil, deep stick engine oil, and the coolant,
3 point of contact any time to climbing a heavy machinery equipment check your seatbelt and make sure all the controls are in free range motion
basic controls
on your right hand you have a the throttle and boom & bucket joy stick control ie to raise and lower the boom, close and open the bucket.
on your left hand you have the stick & swing joystick control ie it the raises and lowers the stick which is attached to the boom and swing is used to move the cabin in 360 degrees.
The track pedals in front the operator are used to drive the machine forward and back wardrobes before you park the machine you need to clear the dirty and debris of the machine tracks and put the bucket flat on the ground and can also grease it later
then after shutting a machine, you make a walk round to check for obvious damage, leaks on the machine
In conclusion be safe, watch out for your friends and surroundings
Excavator training school Requirements
- A copy of the id/ passport
- 2 colour id photos
- PPE ( safety Boots, mask & reflector)
- Own blanket
- Course Fees
